diff --git a/rados/README.md b/rados/README.md
index cc085f45..de5b5cb5 100644
--- a/rados/README.md
+++ b/rados/README.md
@@ -1,64 +1,64 @@
 <!--
 Copyright (c) 2014 - 2015 YCSB contributors. All rights reserved.
 
 Licensed under the Apache License, Version 2.0 (the "License"); you
 may not use this file except in compliance with the License. You
 may obtain a copy of the License at
 
 http://www.apache.org/licenses/LICENSE-2.0
 
 Unless required by applicable law or agreed to in writing, software
 distributed under the License is distributed on an "AS IS" BASIS,
 WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or
 implied. See the License for the specific language governing
 permissions and limitations under the License. See accompanying
 LICENSE file.
 -->
 
 ## Quick Start
 
 This section describes how to run YCSB on RADOS of Ceph.
 
-### 1. Start Ceph
+### 1. Start RADOS
 
-After you start your Ceph cluster, check your cluster’s health first. You can check on the health of your Ceph cluster with the following:
+After you start your Ceph cluster, check your cluster’s health first. You can check on the health of your cluster with the following:
 
     ceph health
 
 ### 2. Install Java and Maven
 
 ### 3. Set Up YCSB
 
 Git clone YCSB and compile:
 
     git clone -b dev-ceph-rados https://github.com/jaemyoun/YCSB.git
     cd YCSB
     mvn -pl com.yahoo.ycsb:rados-binding -am clean package
 
 ### 4. Configuration Parameters
 
 - `rados.configfile`
-  - The Path of Ceph configuration file
-  - Default is '/etc/ceph/ceph.conf'
+  - The path of the Ceph configuration file
+  - Default value is '/etc/ceph/ceph.conf'
 
 - `rados.id`
-  - The user ID to access to pools in order to read and write data
-  - Default is 'admin'
+  - The user id to access the RADOS service
+  - Default value is 'admin'
 
 - `rados.pool`
-  - The pool name to be used for the benchmark
-  - Default is 'data'
+  - The pool name to be used for benchmark
+  - Default value is 'data'
 
-Or, you can set configs with the shell command, EG:
+You can set configurations with the shell command, EG:
 
     ./bin/ycsb load rados -s -P workloads/workloada -p "rados.configfile=/etc/ceph/ceph.conf" -p "rados.id=admin" -p "rados.pool=data" > outputLoad.txt
 
 ### 5. Load data and run tests
 
 Load the data:
 
-    ./bin/ycsb load redis -s -P workloads/workloada > outputLoad.txt
+    ./bin/ycsb load rados -s -P workloads/workloada > outputLoad.txt
 
 Run the workload test:
 
-    ./bin/ycsb run redis -s -P workloads/workloada > outputRun.txt
+    ./bin/ycsb run rados -s -P workloads/workloada > outputRun.txt