##
# Copyright (c) 2016 YCSB contributors All rights reserved.
# Copyright 2014 Basho Technologies, Inc.
#
# Licensed under the Apache License, Version 2.0 (the "License"); you
# may not use this file except in compliance with the License. You
# may obtain a copy of the License at
#
# http://www.apache.org/licenses/LICENSE-2.0
#
# Unless required by applicable law or agreed to in writing, software
# distributed under the License is distributed on an "AS IS" BASIS,
# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or
# implied. See the License for the specific language governing
# permissions and limitations under the License. See accompanying
# LICENSE file.
#

# RiakKVClient - Default Properties
# Note: Change the properties below to set the values to use for your test. You can set them either here or from the
# command line. Note that the latter choice overrides these settings.

# riak.hosts - string list, comma separated list of IPs or FQDNs.
# EX: 127.0.0.1,127.0.0.2,127.0.0.3 or riak1.mydomain.com,riak2.mydomain.com,riak3.mydomain.com
riak.hosts=127.0.0.1

# riak.port - int, the port on which every node is listening. It must match the one specified in the riak.conf file
# at the line "listener.protobuf.internal".
riak.port=8087

# riak.bucket_type - string, must match value of bucket type created during setup. See readme.md for more information
riak.bucket_type=ycsb

# riak.r_val - int, the R value represents the number of Riak nodes that must return results for a read before the read
# is considered successful.
riak.r_val=2

# riak.w_val - int, the W value represents the number of Riak nodes that must report success before an update is
# considered complete.
riak.w_val=2

# riak.read_retry_count - int, number of times the client will try to read a key from Riak.
riak.read_retry_count=5

# riak.wait_time_before_retry - int, time (in milliseconds) the client waits before attempting to perform another
# read if the previous one failed.
riak.wait_time_before_retry=200

# riak.transaction_time_limit - int, time (in seconds) the client waits before aborting the current transaction.
riak.transaction_time_limit=10

# riak.strong_consistency - boolean, indicates whether to use strong consistency (true) or eventual consistency (false).
riak.strong_consistency=true

# riak.strong_consistent_scans_bucket_type - string, indicates the bucket-type to use to allow scans transactions
# when using strong consistency mode. Example: fakeBucketType.
riak.strong_consistent_scans_bucket_type=

# riak.debug - boolean, enables debug mode. This displays all the properties (specified or defaults) when a benchmark
# is started.
riak.debug=false