R7507/rados95711df6ec1amaster
README.md
<!-- Copyright (c) 2016 YCSB contributors. All rights reserved.
Licensed under the Apache License, Version 2.0 (the "License"); you may not use this file except in compliance with the License. You may obtain a copy of the License at
http://www.apache.org/licenses/LICENSE-2.0
Unless required by applicable law or agreed to in writing, software distributed under the License is distributed on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License for the specific language governing permissions and limitations under the License. See accompanying LICENSE file. -->
Quick Start
This section describes how to run YCSB on RADOS of Ceph.
1. Start RADOS
After you start your Ceph cluster, check your cluster’s health first. You can check on the health of your cluster with the following:
ceph health
2. Install Java and Maven
3. Set Up YCSB
Git clone YCSB and compile:
git clone http://github.com/brianfrankcooper/YCSB.git cd YCSB mvn clean package
You can compile only RADOS-binding, EG:
mvn -pl com.yahoo.ycsb:rados-binding -am clean package
You can skip the test, EG:
mvn -pl com.yahoo.ycsb:rados-binding -am clean package -DskipTests
4. Configuration Parameters
- rados.configfile
- The path of the Ceph configuration file
- Default value is '/etc/ceph/ceph.conf'
- rados.id
- The user id to access the RADOS service
- Default value is 'admin'
- rados.pool
- The pool name to be used for benchmark
- Default value is 'data'
You can set configurations with the shell command, EG:
./bin/ycsb load rados -s -P workloads/workloada -p "rados.configfile=/etc/ceph/ceph.conf" -p "rados.id=admin" -p "rados.pool=data" > outputLoad.txt
5. Load data and run tests
Load the data:
./bin/ycsb load rados -s -P workloads/workloada > outputLoad.txt
Run the workload test:
./bin/ycsb run rados -s -P workloads/workloada > outputRun.txt