adding-shape…

manual.tex
View Options

			\documentclass[openright,a4paper,11pt,fleqn]{manual}
			\usepackage{manual}
			\usepackage{manual-macros}

			\IfFileExists{version-definition.tex}{
			\input{version-definition}
			}{
			\newcommand{\version}{2.2}
			}
			\graphicspath{ {./figures/} }
			%%% For references \todo check the coherency
			%% section 3.5 -> Section 3.5
			%% figure 3.5 -> Figure 3.5
			%% equation 3.5 -> Equation (3.5)

			% Title pages and Table of Contents (includes \begin{document})
			\input{manual-titlepages}

			% Introduction chapter
			\input{manual-introduction}

			% The planning to write the documentation
			%\input{manual-planning}

			% The documentation chapter (split in parts)
			\input{manual-gettingstarted}
			\input{manual-feengine}

			%\IfFileExists{manual-lumping.tex}{}{\input{manual-lumping}}

			\input{manual-solidmechanicsmodel}

			\IfFileExists{manual-structuralmechanicsmodel.tex}{\input{manual-structuralmechanicsmodel}}{}

			\IfFileExists{manual-heattransfermodel.tex}{\input{manual-heattransfermodel}}{}

			\input{manual-io}

			\IfFileExists{manual-parallel.tex}{\input{manual-parallel}}{}

			\IfFileExists{manual-contact.tex}{\input{manual-contact}}{}


			% The appendices
			\appendix
			\input{manual-appendix-elements}
			\input{manual-appendix-materials}

			\input{manual-appendix-packages}

			% The backmatter material (index/bibliography, included \end{document})
			\input{manual-backmatter}