lammps/tools/moltemplate/examples/all_atom_examples/nanotube+water/moltemplate_filesceb4da003907efficient_neuronet
lammps/tools/moltemplate/examples/all_atom_examples/nanotube+water/moltemplate_files
ceb4da003907efficient_neuronet
README.sh
README.sh
# This is a small version of a carbon-nanotube, water capillary system.
# It was inspired by this paper:
#
# Laurent Joly, J. Chem. Phys. 135(21):214705 (2011)
#
# Note: To investigate the behavior from that paper, you would have to increase
# the spacing between the two graphene sheets to prevent the water from
# making contact with the lower graphene wall.
#
# Requirements: 1) Set your $MOLTEMPLATE_PATH variable
# 2) The "RIGID" LAMMPS package may be needed later
# To run this system at constant pressure, it might help to compile LAMMPS with
# the optional RIGID package, and use "fix rigid" on the carbon. (Optional.)
#
# Also, if you have not yet done this set your MOLTEMPLATE_PATH environment
# variable to access it. (See installation instructions.)
# Most likely some of the files in this example (like graphene.lt, tip3p2004.lt)
# are not in this directory, but are in the "common" directory.
# Set MOLTEMPLATE_PATH to point to the "common" directory.
#
# -----------------------------------------------------------
#
# To run moltemplate, use:
moltemplate.sh system.lt
# This will generate:system.data, system.in, system.in.init, system.in.settings
# It was inspired by this paper:
#
# Laurent Joly, J. Chem. Phys. 135(21):214705 (2011)
#
# Note: To investigate the behavior from that paper, you would have to increase
# the spacing between the two graphene sheets to prevent the water from
# making contact with the lower graphene wall.
#
# Requirements: 1) Set your $MOLTEMPLATE_PATH variable
# 2) The "RIGID" LAMMPS package may be needed later
# To run this system at constant pressure, it might help to compile LAMMPS with
# the optional RIGID package, and use "fix rigid" on the carbon. (Optional.)
#
# Also, if you have not yet done this set your MOLTEMPLATE_PATH environment
# variable to access it. (See installation instructions.)
# Most likely some of the files in this example (like graphene.lt, tip3p2004.lt)
# are not in this directory, but are in the "common" directory.
# Set MOLTEMPLATE_PATH to point to the "common" directory.
#
# -----------------------------------------------------------
#
# To run moltemplate, use:
moltemplate.sh system.lt
# This will generate:system.data, system.in, system.in.init, system.in.settings
c4science · Help