Homec4science
Diffusion lammps (master) Browse

lammps/doc/write_restart.txt
1138cacffd62master

Last Change
Raw File

write_restart.txt
View Options

"LAMMPS WWW Site"_lws - "LAMMPS Documentation"_ld - "LAMMPS Commands"_lc :c
:link(lws,http://lammps.sandia.gov)
:link(ld,Manual.html)
:link(lc,Section_commands.html#comm)
:line
write_restart command :h3
[Syntax:]
write_restart file :pre
file = name of file to write restart information to :ul
[Examples:]
write_restart restart.equil
write_restart poly.%.* :pre
[Description:]
Write a binary restart file of the current state of the simulation.
See the "read_restart"_read_restart.html command for information about
what is stored in a restart file.
During a long simulation, the "restart"_restart.html command is
typically used to dump restart files periodically. The write_restart
command is useful after a minimization or whenever you wish to write
out a single current restart file.
Similar to "dump"_dump.html files, the restart filename can contain
two wild-card characters. If a "*" appears in the filename, it is
replaced with the current timestep value. If a "%" character appears
in the filename, then one file is written by each processor and the
"%" character is replaced with the processor ID from 0 to P-1. An
additional file with the "%" replaced by "base" is also written, which
contains global information. For example, the files written for
filename restart.% would be restart.base, restart.0, restart.1, ...
restart.P-1. This creates smaller files and can be a fast mode of
output on parallel machines that support parallel I/O for output.
Restart files can be read by a "read_restart"_read_restart.html
command to restart a simulation from a particular state. Because the
file is binary (to enable exact restarts), it may not be readable on
another machine. In this case, the restart2data program in the tools
directory can be used to convert a restart file to an ASCII data file.
Both the read_restart command and restart2data tool can read in a
restart file that was written with the "%" character so that multiple
files were created.
[Restrictions:]
This command requires inter-processor communication to migrate atoms
before the restart file is written. This means that your system must
be ready to perform a simulation before using this command (force
fields setup, atom masses set, etc).
[Related commands:]
"restart"_restart.html, "read_restart"_read_restart.html
[Default:] none
c4science · Help